UV DTF Transfer Instructions and Care



  • INSTRUCTIONS
    •
      • Measure decal/wrap to hard surface and trim any excess material if needed.
      • Clean and dry surface completely using a microfiber cloth. We recommend cleaning with soap and water.
      • Use a squeegee to ensure the entire design transfers to the clear film before placing on a hard surface. (This helps reduce air bubbles).
      • Be sure you know where you want to place your design. The adhesive is very strong. Once the design is placed you can not remove it.
      • Peel the white backing starting from a corner off of the clear film.
      • Confirm the direction of the adhesive and place the transfer on your hard surface. Press decal/wrap with HARD pressure USING HANDS. (The heat from your fingers helps the design adhere to the surface).
      • LIGHTLY USE SQUEEGEE to remove any remaining air bubbles.
      • SLOWLY peel the clear film off and you are done!
      • WAIT 24HR BEFORE WASHING AND USING

    • UV DTF is Waterproof and scratch resistant
    • NOT DISHWASHER SAFE 
    • NOT MICROWAVE SAFE
    • HAND WASH ONLY
    • DO NOT SOAK
    • AVOID EXTREME HEAT
    • DO NOT SCRUB
    • No heat/mug press required.


  • APPLICABLE SURFACES
    •
        • UV DTF adhesives are extremely versatile and can be applied to hard surfaces such as glassware, metal, plastic, ceramic or any hard surfaces.
  • DISCLAIMER
    •
        • All transfer sizes are listed within the product details. Colors may vary slightly from image mockup as you are viewing on a screen monitor. We are not responsible for any UV DTF Transfers that are incorrectly applied, please follow instructions provided in each order.